NEW PRODUCT,Gasoline chain saw 52cc,
GASOLINE CHAIN SAW Chinese Guide bar .
easy starting
Port: NingBo
Minimum Order Quantity: 500 Piece/Pieces
Supply Ability: 30000 Piece/Pieces per Month
Payment Terms: L/C,T/T
Contact SupplierPackaging Detail: 1). Boxed:50*26.5*26.5cm/ 2pcs----3700PCS2). Carton:51*53*40.5/4pcs----3000PCS
Delivery Detail: 15days~20days
1.NEW PRODUCT,Gasoline chain saw 52cc.
2.GASOLINE CHAIN SAW Chinese Guide bar
3.CIYLINER Volume:52cc
4.Power output:2.0kw/2.8hp
5.G.W.N.W.:7.0KGS/5.90KGS
6.Fuel Capacity: 550ml
7.Oil capacity: 260ml
8.Chain Manufacturer: CHINESE CHAIN
9.Guide bar: 20"
10.Chain pitch: 0.325"
11.Chain Gauge: 0.058"
12.Sound pressure level : 102.0dB(A)
13.Sound Power level: 113.0dB(A)
14.Vibration levels left/right : 4.15/4.1m/s2
15.Max speed: 11000 +/- 500r/Min
Import gasoline saws use maintenance and troubleshooting
In 1, an air filter air filter capable of filtering of chain saw powder dust and other foreign matter, prevent foreign body into the cylinder, causing the piston to bad accident. When the chain saw appear gas flameout, inability to work, engine overheating, there may be an air filter dirty need maintenance. Air filter should be verified before qualified work, clean air filter alignment of the sun light observation, should be thorough, bright, unqualified air filter is covered with wood residue, dust, touch feel hard, this time with hot soapy water wash, dry, clean, transparent, soft, air filter, party can ensure the normal work of chain saw.
In 2, the correct ratio of mixed oil import chainsaw used fuel is 90 # ( 93 # ), gasoline and 2T oil according to volumetric ratio of 20: 1 ratio, too much oil will startup difficulties caused by work, smoke, excessive oil causes incomplete combustion, carbon deposit is excessive, resulting in engine cylinder, so the ratio of mixed oil should be reasonable, not too much oil is good.
3, chain saw oil matters needing attention for the saw chain saw chain oil and wood cutting process, provide lubrication oil and reduce the saw chain and guide plate friction heat, the plate forming protection. Before, should check whether the chain oil filling, after starting up, saw chain oil should be thrown out, on the ground out of oil can be used only for work, lack of chain oil chain saw will be working at high temperature annealing, cause chain saws were scrapped prematurely. As a concrete manifestation of working tooth easy obtuse, short-term inside an elongated, even breaking.
4, the use and maintenance of the saw chain saw chain before use, should be in the chain oil thrown out before work, after work should be soaked in oil bowl. In the working process should pay attention to changes in the sawtooth cutting debris, blunt is not sharp, application dedicated file on the zigzag chain cutting trimming, to ensure that the zigzag sharp, correct trimming method is: along the cutting direction and gear, but towards the tooth direction and tooth, can not be pulled back, and saw file the chain angle of 30 degrees, the angle of the saw chain more blunt, angle is too small, it causes the saw chain is not durable, not sharp saw chain will increase the engine load, the resulting incision burnt, clamping saw, to guide adverse effect.