CE transformer built in it
Cut and Seal rope(nylon, PP), Webbing, braiding tube.
Minimum Order Quantity: 1 Piece/Pieces
Supply Ability: 2000 Piece/Pieces per Month
Payment Terms: L/C,T/T
Contact SupplierPackaging Detail: Unit carton box:26/17.5/14.5 cm, weight:2.0kgCartong Box: 55/39.5/32.5 cm, weight:18kg 8 pcs/Caton
Delivery Detail: 7-25days
The blade is mounted at the front, the operator can hold the cutting material effortlessly, this design make operator more comfortable than previous version.
Application:
Cut rope(nylon, PP), Webbing, braiding tube.
Operate:
Preparation
A. Loosen the knurled nut when device is cold,
insert each leg of the blade and tighten the knurled
nuts, make sure that the blade and cutting head
have optimal contact.
B. Power on.
Cutting
A. Avoid direct short circuit between cutting heads.
B. switch on the hot knife to “ON”
C. Adjust the temperature from low to high range, one
can have a try on the small piece of foam
D. Close to the blade, and press a bit, the rope will be cut.
E. Clean the blade by brush.
Caution
A.Always operate the Hot Knife in well ventilated space
B. Never burn off excess residue on the hot knife blade. The blades will overheat, warping the blade.
C. DO NOT heat the blade when not operating, otherwise, the blade may warp.
D. Allow blades to cool before handling. A hot blade may cause injury or burns to exposed surfaces
Specification:
Model | KD-9F |
Voltage | AC230V/50Hz |
Weight | 1.5Kg |
Power | MAX.60W |
Temp. of blade | Up to 500°C in seconds |
Power cord length | 2.5M |
Size | 20/11/9cm |
Practicable blade:No. 25