PDC bit for petroleum field or PDC bits of oil field - PDC Bit 1

PDC bit for petroleum field or PDC bits of oil field

PDC oil bits/ PCD blanks

HM6163 Series

HM6163S Series

IADC:M323/M423

· 6 spiral blade, large PDC cutter, parabolic profile and deep blade design;

· Backup cutters or studs restrict cutting depth to reduce torque fluctuation and extend service life, available with trimmers and up-reamers;

· Slant gage may improve bit guidance and stability;

· Applicable to drill in soft to medium formations and directional drilling;

Note: We can design and manufacture any types and sizes of PDC bits according to customer requirements.

Recommended Diamond Bit Operation Procedure

Preparation Before Drilling

l Inspect previous bit for body damage, lost cutters or inserts, etc. Make sure no hard objects exist at bottom hole such as teeth, tungsten carbide and steel pieces. Clean the bottom if necessary.

l Handle the bit with care. Place the bit on wooden pad or rubber mat. Do not set the bit directly on the steel floor.

l Check the cutting elements for damage and inside of bit for any foreign matter and Install nozzles properly as requested, ensure that nozzle O-ring are in place.

Making Up the Bit

l Clean and grease the pin or box.

l Fit the breaker to the bit, lower the drill string to the pin and engage the threads.

l Locate the bit and breaker into the rotary bushing, and make-up to the recommended torque.

Tripping Down the Hole

l Pay attention to the presence and location of tight spots encountered when pulling the previous bit out of the hole. Trip bit slowly through tight spots, dog legs or ledges.

l Wash the bottom hole with rated flow at 60rpm when the drill string is approximately 30m from the bottom.

l Approach the bottom cautiously by observing the weight and rotary-torque indicators. Tag bottom gently and pick up approximately half a meter off bottom. Circulate for 5 to 10 minutes with rated flow.

Reaming

l Reaming long sections of under gage hole with a diamond bit is not recommended.

l If reaming is necessary, ream slowly with low torque at rated flow rate, 60 rpm and 10 to 20KN weight-on-bit.

Bottom-Hole Patterning

l Lower bit to bottom at rated flow rate.

l Drill slowly using 10 to 20kn weight-on-bit and 60rpm to establish the bottom-hole pattern for at least one meter.

Drilling

l Reduce rotary speed when drilling through abrasive or hard sand mud-rock stringers to extend bit life.