ATTEN AT980 LCD Digital dispaly ESD safe 80W Soldering Iron Station AT980

Specifications and Product Details:

ATTEN AT980 LCD Digital dispaly ESD safe 80W Soldering Iron Station

AT980D Features

ESD safe – suitable for work on static-sensitive components

Three programmable preset temperature buttons

Easy to read white-on-blue LCD with temperature in °C or °F

Temperature range: 150°C~450°C (302°F~842°F)

On/Off switch on side of unit

Includes soldering iron, stand, and sponge

Additional range of soldering tips available

Technical Specifications

Input Voltage: AC 220V(110V optional)

Input Frequency: 50/60Hz

Power Consumption: 80W (max)

Temperature Range: 150~450°C

Tip and ground impedance: <2 Ohm

Tip and ground potential: <5mV

Heating Element:4 cores,80W

Standard tip: AT-900M

Parts List

Soldering Iron	1PC
Iron holder	1SET
Power Cord	1PC
Manual	1Copy
Clean sponge	1PC

Operation

Prepare:Plug the handle with main body and turn tight, place it on stand, connect power source.

Dial temperature:Dial the knob to a temperature value you required, switch on the main body, temperature indicator light as a result. Temperature indicator flickers means the temperature of iron tip reaches to set value. Now you can do the soldering job.

Calibrate temperature:When the heating element or soldering tip is replaced, you need calibrate the tip temperature. Please set temperature at 350°C, 30 seconds later fine-tune the “CAL” in panel by a “-“or “+”screwdriver.

Self examination:If the machine cannot reach to a set temperature within 30 seconds or longer, it might due to the malfunction of heating element. How to replace it please refer to Chapter: replacing the heating element.

ATTEN INSTRUMENTS

RF Microwave Instruments

RF Microwave Components

Spectrum Analyzers.Regulated DC Power Supply

Switching DC Power Supply.Digital Storage Oscilloscope

Signal Generator.Attenuator.Amplifier.850 Rework Station

936 Constant Temp Soldering Station

Electronic Instruments.Electronic Tools

Warning

Temperature of iron tip will be up to 200 – 400 ºC after connecting power, so it may lead to injury

or fire because of improper usage. Please abide the following terms:

Don't touch the iron tip or surrounding metals.

Never operate it near the flammable gas or substance.

Disconnect from power source if the unit will not be used for long periods. Switch off power during short breaks.

Replace accessories or iron tip after turning off the station and let it cool down.

Never operate this device, if you don't have soldering experience or enough knowledge to use.

Keep away from children.

Safety Precautions

Caution: Improper usage can cause serious injury to personnel and/or damage to equipment. For

personnel safety, please follow these precautions:

Never use it to do other work except soldering.

Do not subject the main unit to physical shock. Never drop or sharply jolt the unit.

Don't change the device at will

Replace loss items with original accessories of ATTEN.

Don't put it in water or operate with wet hands

Don't pull the cable but hold tightly the plug when you take it out of plug.

Please keep the operate place well ventilated since soldering process produce smoke.

Don't play with other people or would be easy to hurt others or yourself.

Care and Maintenance

Keep the soldering station dry; if it gets wet, dry it immediately.

Use the soldering station only in normal temperature environments.

Keep the soldering station away from dust and dirt.

The soldering iron tip should be cleaned after use by wiping it on the damp sponge found in the soldering iron stand. This is to get rid of burnt solder or fluxes that cause oxidation on the tip.