52cc 2.2kw power chain saw - RQ22-CS5200

Product Description:

1, brand new streamlined body design, the rear handle embedded , feel comfortable when holding,more humanized design

2, spiral bevel gear with high hardness , adopt the Internationalization

technology, lower noise, operated more smoothly.

3, self-locking switch,high security, a straight handle as well as the main handle, to grasp more firmly.

applicable scope:

For forest harvesting, bucking, pruning, etc., and bucking yards, railroad ties cut sawing and other operations.

Performance characteristics:

Advantages: powerful, highly efficient vibration sawing, and low cost when cutting tree. It has become the dominant handheld mechanical harvesting machine.

5200 Gasoline chain saw

1. Engine type --air-cooling,single cylinder, 2-stroke system.
2. Displacemen--52cc.
3. Max cutting diamete--500mm.
4. Rated output power--2.0kw/7500r/min.
5. Idling speed--2800r/min.
6. Gasoline/2-cycle oil mixing ratio--1/25.
7. Ignition system--C.D.I
8. Starter system--hand-starter.
9. Fuel tank capacity--550ml.
10. Engine oil tank capacity--260ml.
11. Carburetor--diaphragm.
12. Guide bar size--18/ 20/22.
13. Chian--Carton USA

Gasoline Chain Saw Precautions:

1) Must be familiar with instruction before using the chain saw, in strict accordance with the requirements of operating instructions to ensure the safety and life cycle of the product.

2)Pay attention to the tightness of chain guide(hand pull the chain, the chain and guide spacing of 1 cm) during the installating process , or else it will influence the effects.

3) Mixture of gasoline and oil rating is 25:1, but due to regional differences in the quality of oil, we recommend a ratio of 20:1, recommended engine oil as the Mobil brand two-stroke engine oil.

4) For the first time,it must first start the machine for 5 minutes before working.

5) After operating , must wait for the chain guide under the oil before working(oil pump).

6) Affected by the transport, chain saw may be screw loose, tighten according to the instructions before using , in general, not recommended disassembling.

7)Before using, carburetor must be cleaned after every 100 hours working.

8) Air filter must be cleaned after every 8 hours working.

9) Chain should be replaced if blunt, or else it will affect the effects and the chain saw life cycle.

10) When not in use it is better to be packed by plastic bags, avoiding dust and moisture into the machine.

11) 25F chainsaw largest guide the chain's configuration is: 12 inches; 45F chainsaw largest guide chain configurations: 18 inch; 52F chainsaw largest guide chain configuration for 20-inch; 62F chainsaw largest guide chain configuration for 22 inch. May cause the high temperature over the range of possible machine configurations temperature, then turn off, influence the using effect and machine life cycle( use the above models, chain guides should be reduced by 2 inches for the benefit in summer).

pcaking:

about us: